Cisco Air Lap521g A K9 Manual Transfer
.ETTING TARTED UIDE Cisco Aironet 3500 Series Lightweight Access Point About this Guide Safety Instructions Unpacking Overview Configuring the Access Point Mounting the Access Point Deploying the Access Point on the Wireless Network Troubleshooting Declarations of Conformity and Regulatory Information.About this Guide This Guide provides instructions on how to install and configure your Cisco Aironet 3500 Series Access Point. This guide also provides mounting instructions and limited troubleshooting procedures. Safety Instructions Translated versions of the following safety warnings are provided in the translated safety warnings document that is shipped with your access point.Warning This product relies on the building’s installation for short-circuit (overcurrent) protection.
Cisco Air Lap521g A K9 Manual Transfer Case
Ensure that the protective device is rated not greater than: 20A. Statement 1005 Warning Do not operate your wireless network device near unshielded blasting caps or in an explosive environment unless the device has been modified to be especially qualified for such use.Step 2 Step 3 Verify that you have received the items listed below. If any item is missing or damaged, contact your Cisco representative or reseller for instructions.
3500 series access point – Mounting bracket (selected when you ordered the access point) –.Overview The following illustrations show the access point connections and features. The 3500e access point has external antenna connectors; the 3500i access point has integrated antennas and does not have external connectors. Figure 1 Access Point Ports and Connections (top) 2.4-GHz antenna connector B 5-GHz antenna connector A (labelled with black text).Figure 2 Access Point Ports and Connections (bottom) Kensington lock slot Console port Power connection Security padlock and hasp (padlock not included) Ethernet port Mounting bracket pins (feet for desk or table-top mount).The discovery process using CAPWAP is identical to the Lightweight Access Point Protocol (LWAPP) used with previous Cisco Aironet access points. LWAPP-enabled access points are compatible with CAPWAP and conversion to a CAPWAP controller is seamless. DHCP server discovery—This feature uses DHCP option 43 to provide controller IP addresses to the access points.
Cisco switches support a DHCP server option that is typically used for this capability. For more information about DHCP option 43, see the “Configuring DHCP Option 43 and DHCP Option 60”.Cisco recommends that you make a site map showing access point locations so that you can record the device MAC addresses from each location and return them to the person who is planning or managing your wireless network.Network WLAN Controller Guide: Cisco 440x Series WLAN Controllers for additional information. Set the Cisco wireless LAN controller as the master so that new access points always join with d. Make sure DHCP is enabled on the network. The access point must receive its IP address.If the access point remains in this mode for more than five minutes, the access point is Note unable to find the Master Cisco wireless LAN controller.
Cisco Air Lap521g A K9 Manual Transfer System
Check the connection between the access point and the Cisco wireless LAN controller and be sure that they are on the same subnet.If the access point shuts down, check the power source. After the access point finds the Cisco wireless LAN controller, it attempts to download the new operating system code if the access point code version differs from the Cisco wireless LAN controller code version.Cisco wireless LAN controller. Also, if the access point is not on the same subnet as the Cisco wireless LAN controller, be sure that there is a properly configured DHCP server on the same subnet as the access point.